Products丨Application of thixotropic agent in ink industry
Release time:
2023-06-02
What is thixotropy? What effect does thixotropy have on ink?
Thixotropy: refers to the property that when an object (such as paint or coating) is sheared, its viscosity decreases, and when the shearing stops, its viscosity increases; when it is sheared, its viscosity increases, and when the shearing stops, its viscosity decreases again.


The larger the closed loop area, the higher the thixotropy of the coating.
If the hysteresis loop coincides with the original curve, it indicates that the coating is not thixotropic.
In the actual life and use of ink, different stages will have different viscosity requirements.
During storage, the ink is required to have a high viscosity to prevent sedimentation.
During the printing process, the ink is required to have low viscosity and be able to print quickly.
During the drying process, the ink is required to have a certain viscosity to prevent sagging and help leveling.
Therefore, thixotropy is an essential property for ink.
What is Haiyi's solution for thixotropy?
Common thixotropic agents used in inks are of the following types:

Different types of thixotropic agents have their own unique performance characteristics:

Different thixotropic agents have their own advantages and disadvantages. Our company has experience in using a variety of thixotropic agents. You are welcome to contact our sales staff for communication and choose the product that best suits your company!
Questions & Answers
Q: Will adding alcohol to the formula system destroy the thixotropic effect?
Answer: In the formulation system that requires the addition of alcohol, our company recommends adding two types of thickeners: fumed silica and sepiolite. These two types of thixotropic products have a wide range of adaptability and a short onset time. After being diluted with alcohol, the thixotropic properties will be restored very quickly.
The recommended test for fumed silica is A200.
The recommended test for meerschaum is B42.
Question: Is it necessary to grind gas silicon? Some products do not have a grinding process in their production process.
A: Conventional gas silicones must be ground to achieve a thixotropic effect. However, our new brand E972 is an easily dispersed gas silicone that only needs to be dispersed at high speed! At the same time, it can bring the following properties to the ink: good anti-settling effect, especially suitable for various special pigments such as metal, pearlescent inorganic, etc. It can improve the water resistance of ink or light. It can increase the friction coefficient of the ink or light surface, but has little effect on the gloss.
Q: I have tested hydroxyethyl cellulose before, but it cannot be dissolved. Is there any recommended method?
A: The solubility of our hydrophobically modified hydroxyethyl cellulose is significantly improved compared to traditional hydroxyethyl cellulose. The specific dissolution method is as follows: First, the concentration of the mother liquor cannot be higher than 2.5%-3%, otherwise the mother liquor will be difficult to operate. Second, the surface of NATROSOL (HMHEC) has been treated with delayed hydration, which allows it to dissolve slowly rather than dissolve quickly to cause agglomeration and gelation. Therefore, adjusting the pH to a weak alkaline state with a pH regulator can accelerate the dissolution of NATROSOL hydrophobically modified hydroxyethyl cellulose.
In addition, NATROSOL hydrophobically modified hydroxyethyl cellulose (HMHEC) can be added in both the grinding and paint mixing stages. Adding it in the grinding stage can appropriately increase the viscosity of the grinding base and improve the grinding efficiency; adding it in the ink mixing stage is recommended in the form of an aqueous solution.